|
2MM REGA SPACER
Where a turntable has a Rega tonearm, there is no
manual adjustment to the height of the tonearm at the pivot end. In
some cases, this may preclude the setting of an accurate stylus rake
angle for the cartridge. We can supply 2mm Tonearm Spacers in order
to increase the height of the tonearm at the pivot end of the arm.
They are placed between the underside of the tonearm pivot and the
top of the plinth or tonearm board of the turntable.
Picture:
Ringmat 2mm Rega Tonearm Spacers
In order to do this, first ensure the stylus tip and
cantilever are protected during the ensuing process and that the
tonearm lead is safely disconnected from the phono stage. Also,
note the position/alignment of the tonearm to the platter and sides
of the plinth so that, when repositioning the arm after the Tonearm
Spacer has been added, the same alignment is retained. Start by
unscrewing the retaining nut, which holds the tonearm in place and
is situated under the plinth or tonearm board, and then removing it
and withdrawing the tonearm from the turntable. Pass the phono
plugs through the 2mm Spacer and draw the Spacer up to a position
directly underneath the tonearm pivot. Replace the tonearm, leaving
the Spacer between the underside of the pivot and the top of the
plinth or tonearm board and secure the retaining nut as it was
before dismantling the tonearm from the turntable. Before
tightening the nut, check that the tonearm is correctly aligned.
-
Back to Decoupling Products -
|
